Compare any two graphics cards:
GeForce 9800 GT 512MB vs Radeon R9 M390X
IntroThe GeForce 9800 GT 512MB makes use of a 65/55 nm design. nVidia has clocked the core speed at 600 MHz. The GDDR3 RAM is set to run at a speed of 900 MHz on this particular card. It features 112 SPUs along with 56 TAUs and 16 ROPs.Compare those specifications to the Radeon R9 M390X, which comes with clock speeds of 723 MHz on the GPU, and 1250 MHz on the 4096 MB of GDDR5 memory. It features 2048 SPUs along with 128 Texture Address Units and 32 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthIn theory, the Radeon R9 M390X should perform a lot faster than the GeForce 9800 GT 512MB in general. (explain)
Texel RateThe Radeon R9 M390X will be quite a bit (approximately 175%) more effective at AF than the GeForce 9800 GT 512MB. (explain)
Pixel RateIf using a high resolution is important to you, then the Radeon R9 M390X is the winner, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of information (in units of MB per second) that can be moved past the external memory interface within a second. It is worked out by multiplying the interface width by the speed of its memory. If it uses DDR RAM, the result should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the faster the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that are processed in one second. This number is calculated by multiplying the total texture units of the card by the core speed of the chip. The better this number, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second. Pixel Rate: Pixel rate is the maximum number of pixels the graphics card could possibly write to its local memory in a second - measured in millions of pixels per second. The figure is worked out by multiplying the number of Render Output Units by the clock speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel fill rate is also dependant on many other factors, especially the memory bandwidth of the card - the lower the memory bandwidth is, the lower the ability to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!