Compare any two graphics cards:
Radeon HD 6750 vs Radeon R9 M390X
IntroThe Radeon HD 6750 uses a 40 nm design. AMD has set the core frequency at 725 MHz. The GDDR5 memory is set to run at a frequency of 1000 MHz on this specific card. It features 720 SPUs along with 36 Texture Address Units and 16 ROPs.Compare those specifications to the Radeon R9 M390X, which comes with core speeds of 723 MHz on the GPU, and 1250 MHz on the 4096 MB of GDDR5 RAM. It features 2048 SPUs as well as 128 Texture Address Units and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon R9 M390X, in theory, should perform a lot faster than the Radeon HD 6750 in general. (explain)
Texel RateThe Radeon R9 M390X is a lot (about 255%) better at anisotropic filtering than the Radeon HD 6750. (explain)
Pixel RateThe Radeon R9 M390X will be a lot (about 99%) more effective at full screen anti-aliasing than the Radeon HD 6750, and also will be able to handle higher resolutions better. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of information (measured in megabytes per second) that can be moved past the external memory interface in one second. The number is worked out by multiplying the interface width by the speed of its memory. If the card has DDR type RAM, it must be multiplied by 2 once again. If DDR5, multiply by ANOTHER 2x. The higher the bandwidth is, the better the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be processed per second. This number is worked out by multiplying the total number of texture units by the core clock speed of the chip. The better the texel rate, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed per second. Pixel Rate: Pixel rate is the maximum number of pixels that the graphics card could possibly write to its local memory in one second - measured in millions of pixels per second. Pixel rate is worked out by multiplying the amount of colour ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel fill rate also depends on quite a few other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!