Compare any two graphics cards:
GeForce GTX 260 vs Radeon R7 250X 2GB
IntroThe GeForce GTX 260 features a GPU clock speed of 576 MHz, and the 896 MB of GDDR3 memory is set to run at 999 MHz through a 448-bit bus. It also is made up of 192 SPUs, 64 Texture Address Units, and 28 ROPs.Compare all of that to the Radeon R7 250X 2GB, which has core speeds of 1000 MHz on the GPU, and 1125 MHz on the 2048 MB of GDDR5 memory. It features 640 SPUs as well as 40 Texture Address Units and 16 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 260 should be 55% quicker than the Radeon R7 250X 2GB overall, due to its higher bandwidth. (explain)
Texel RateThe Radeon R7 250X 2GB is a bit (about 9%) better at texture filtering than the GeForce GTX 260. (explain)
Pixel RateIf using lots of anti-aliasing is important to you, then the GeForce GTX 260 is superior to the Radeon R7 250X 2GB, though only just barely. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of data (measured in megabytes per second) that can be transferred past the external memory interface within a second. It is worked out by multiplying the card's interface width by its memory speed. If the card has DDR memory, it must be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The better the card's memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be applied per second. This number is calculated by multiplying the total texture units of the card by the core speed of the chip. The better this number, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second. Pixel Rate: Pixel rate is the maximum number of pixels the graphics card can possibly write to its local memory in one second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of Raster Operations Pipelines by the the core clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate is also dependant on quite a few other factors, especially the memory bandwidth of the card - the lower the memory bandwidth is, the lower the ability to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!