GeForce 8600 GT 512MB DDR2 vs Radeon HD 5450

Intro

Compare all that to the Radeon HD 5450, which comes with a core clock speed of 650 MHz and a DDR3 memory speed of 800 MHz. It also features a 64-bit memory bus, and uses a 40 nm design. It is comprised of 80(16x5) SPUs, 8 TAUs, and 4 ROPs.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

Radeon HD 5450		19 Watts
GeForce 8600 GT 512MB DDR2		47 Watts
	Difference: 28 Watts (147%)

Memory Bandwidth

Both cards have the exact same memory bandwidth, so in theory they should perform the same. (explain)

Texel Rate

The GeForce 8600 GT 512MB DDR2 will be quite a bit (more or less 66%) better at texture filtering than the Radeon HD 5450. (explain)

GeForce 8600 GT 512MB DDR2		8640 Mtexels/sec
Radeon HD 5450		5200 Mtexels/sec
	Difference: 3440 (66%)

Pixel Rate

The GeForce 8600 GT 512MB DDR2 will be a lot (approximately 66%) faster with regards to FSAA than the Radeon HD 5450, and also capable of handling higher screen resolutions while still performing well. (explain)

GeForce 8600 GT 512MB DDR2		4320 Mpixels/sec
Radeon HD 5450		2600 Mpixels/sec
	Difference: 1720 (66%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of information (measured in megabytes per second) that can be moved across the external memory interface in a second. It's worked out by multiplying the card's interface width by its memory clock speed. In the case of DDR type memory, it should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The better the memory bandwidth, the better the card will be in general. It especially helps with AA, HDR and high resolutions.

Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are applied per second. This is calculated by multiplying the total amount of texture units of the card by the core speed of the chip. The higher the texel rate, the better the video card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels in one second.

Pixel Rate: Pixel rate is the most pixels the video card can possibly write to its local memory in one second - measured in millions of pixels per second. Pixel rate is worked out by multiplying the number of ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel rate is also dependant on lots of other factors, especially the memory bandwidth of the card - the lower the bandwidth is, the lower the potential to reach the maximum fill rate.