GeForce 9600 GT 512MB vs GeForce GTX 550 Ti

Intro

Compare that to the GeForce GTX 550 Ti, which comes with clock speeds of 900 MHz on the GPU, and 1026 MHz on the 1024 MB of GDDR5 RAM. It features 192 SPUs along with 32 TAUs and 24 Rasterization Operator Units.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce 9600 GT 512MB		95 Watts
GeForce GTX 550 Ti		116 Watts
	Difference: 21 Watts (22%)

Memory Bandwidth

Theoretically speaking, the GeForce GTX 550 Ti should perform a lot faster than the GeForce 9600 GT 512MB overall. (explain)

GeForce GTX 550 Ti		98496 MB/sec
GeForce 9600 GT 512MB		57600 MB/sec
	Difference: 40896 (71%)

Texel Rate

The GeForce GTX 550 Ti will be much (approximately 38%) faster with regards to AF than the GeForce 9600 GT 512MB. (explain)

GeForce GTX 550 Ti		28800 Mtexels/sec
GeForce 9600 GT 512MB		20800 Mtexels/sec
	Difference: 8000 (38%)

Pixel Rate

If using a high resolution is important to you, then the GeForce GTX 550 Ti is a better choice, and very much so. (explain)

GeForce GTX 550 Ti		21600 Mpixels/sec
GeForce 9600 GT 512MB		10400 Mpixels/sec
	Difference: 11200 (108%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the maximum amount of information (counted in megabytes per second) that can be moved over the external memory interface within a second. It is worked out by multiplying the bus width by the speed of its memory. If the card has DDR type RAM, it must be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the better the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions.

Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be applied in one second. This figure is worked out by multiplying the total texture units by the core speed of the chip. The higher the texel rate, the better the video card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second.

Pixel Rate: Pixel rate is the maximum amount of pixels the graphics card can possibly record to the local memory in a second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of colour ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel rate is also dependant on quite a few other factors, especially the memory bandwidth - the lower the bandwidth is, the lower the potential to reach the max fill rate.