Compare any two graphics cards:
Radeon R7 250 vs Radeon RX 590
IntroThe Radeon R7 250 features clock speeds of 1000 MHz on the GPU, and 1150 MHz on the 1024 MB of GDDR5 RAM. It features 384 SPUs along with 24 TAUs and 8 Rasterization Operator Units.Compare those specs to the Radeon RX 590, which uses a 12 nm design. AMD has clocked the core frequency at 1469 MHz. The GDDR5 RAM is set to run at a frequency of 2000 MHz on this model. It features 2304 SPUs along with 144 TAUs and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthPerformance-wise, the Radeon RX 590 should theoretically be quite a bit superior to the Radeon R7 250 in general. (explain)
Texel RateThe Radeon RX 590 should be much (about 781%) faster with regards to AF than the Radeon R7 250. (explain)
Pixel RateIf running with high levels of AA is important to you, then the Radeon RX 590 is the winner, by a large margin. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of data (counted in MB per second) that can be transferred past the external memory interface within a second. It's worked out by multiplying the card's bus width by its memory speed. If it uses DDR RAM, it should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The better the card's memory bandwidth, the better the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are applied in one second. This is worked out by multiplying the total amount of texture units of the card by the core clock speed of the chip. The better the texel rate, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second. Pixel Rate: Pixel rate is the most pixels that the graphics card can possibly write to its local memory per second - measured in millions of pixels per second. The number is worked out by multiplying the number of colour ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - also called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel output rate also depends on many other factors, most notably the memory bandwidth of the card - the lower the bandwidth is, the lower the potential to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!