Compare any two graphics cards:
Radeon HD 4850 2GB vs Radeon RX 550
IntroThe Radeon HD 4850 2GB has a clock frequency of 625 MHz and a GDDR4 memory frequency of 993 MHz. It also makes use of a 256-bit bus, and uses a 55 nm design. It is comprised of 800(160x5) SPUs, 40 Texture Address Units, and 16 ROPs.Compare that to the Radeon RX 550, which features a GPU core clock speed of 1100 MHz, and 2048 MB of GDDR5 memory set to run at 1750 MHz through a 128-bit bus. It also is made up of 512 Stream Processors, 32 TAUs, and 16 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthAs far as performance goes, the Radeon RX 550 should in theory be much superior to the Radeon HD 4850 2GB overall. (explain)
Texel RateThe Radeon RX 550 should be a lot (about 41%) better at texture filtering than the Radeon HD 4850 2GB. (explain)
Pixel RateIf running with a high screen resolution is important to you, then the Radeon RX 550 is a better choice, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the max amount of data (measured in megabytes per second) that can be transferred past the external memory interface in one second. The number is worked out by multiplying the card's bus width by its memory clock speed. In the case of DDR memory, it must be multiplied by 2 again. If DDR5, multiply by ANOTHER 2x. The better the card's memory bandwidth, the faster the card will be in general. It especially helps with AA, HDR and higher screen resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be processed per second. This figure is calculated by multiplying the total amount of texture units by the core clock speed of the chip. The higher this number, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second. Pixel Rate: Pixel rate is the most pixels the graphics card could possibly record to the local memory in a second - measured in millions of pixels per second. Pixel rate is worked out by multiplying the amount of colour ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate is also dependant on quite a few other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the ability to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!