Compare any two graphics cards:
Radeon HD 4770 vs Radeon RX 460 2GB
IntroThe Radeon HD 4770 comes with a GPU clock speed of 750 MHz, and the 512 MB of GDDR5 RAM is set to run at 800 MHz through a 128-bit bus. It also is made up of 640(128x5) SPUs, 32 Texture Address Units, and 16 Raster Operation Units.Compare those specs to the Radeon RX 460 2GB, which comes with core speeds of 1090 MHz on the GPU, and 1750 MHz on the 2048 MB of GDDR5 memory. It features 896 SPUs as well as 56 TAUs and 16 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthAs far as performance goes, the Radeon RX 460 2GB should theoretically be a lot better than the Radeon HD 4770 in general. (explain)
Texel RateThe Radeon RX 460 2GB should be a lot (about 154%) better at texture filtering than the Radeon HD 4770. (explain)
Pixel RateIf running with high levels of AA is important to you, then the Radeon RX 460 2GB is the winner, by a large margin. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of data (counted in MB per second) that can be transported over the external memory interface in one second. The number is calculated by multiplying the interface width by its memory speed. In the case of DDR type memory, the result should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The higher the card's memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that are applied in one second. This figure is calculated by multiplying the total number of texture units of the card by the core clock speed of the chip. The better this number, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second. Pixel Rate: Pixel rate is the maximum amount of pixels the video card can possibly write to its local memory per second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the amount of Render Output Units by the the card's clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate is also dependant on many other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!