Compare any two graphics cards:
GeForce GT 310 vs Radeon RX 470 4GB
IntroThe GeForce GT 310 features a GPU core clock speed of 589 MHz, and the 512 MB of DDR2 memory is set to run at 1000 MHz through a 64-bit bus. It also is comprised of 16 SPUs, 8 TAUs, and 4 ROPs.Compare that to the Radeon RX 470 4GB, which has a GPU core clock speed of 926 MHz, and 4096 MB of GDDR5 RAM running at 1650 MHz through a 256-bit bus. It also features 2048 Stream Processors, 128 Texture Address Units, and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon RX 470 4GB should theoretically be a lot faster than the GeForce GT 310 overall. (explain)
Texel RateThe Radeon RX 470 4GB will be quite a bit (approximately 2415%) better at texture filtering than the GeForce GT 310. (explain)
Pixel RateIf using a high resolution is important to you, then the Radeon RX 470 4GB is the winner, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (measured in megabytes per second) that can be moved across the external memory interface within a second. It's calculated by multiplying the interface width by the speed of its memory. If the card has DDR type RAM, it must be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The better the bandwidth is, the better the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be applied per second. This figure is calculated by multiplying the total texture units of the card by the core speed of the chip. The better the texel rate, the better the video card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in a second. Pixel Rate: Pixel rate is the maximum number of pixels that the graphics card can possibly write to the local memory in a second - measured in millions of pixels per second. The number is worked out by multiplying the amount of ROPs by the the core speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate also depends on many other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the potential to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!