GeForce 8800 GS vs Radeon R9 M380

Intro

Compare all that to the Radeon R9 M380, which comes with a GPU core clock speed of 1000 MHz, and 4096 MB of GDDR5 memory set to run at 1500 MHz through a 128-bit bus. It also is comprised of 640 Stream Processors, 40 Texture Address Units, and 16 Raster Operation Units.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Memory Bandwidth

In theory, the Radeon R9 M380 should be much faster than the GeForce 8800 GS in general. (explain)

Radeon R9 M380		96000 MB/sec
GeForce 8800 GS		38400 MB/sec
	Difference: 57600 (150%)

Texel Rate

The Radeon R9 M380 will be a lot (more or less 52%) better at texture filtering than the GeForce 8800 GS. (explain)

Radeon R9 M380		40000 Mtexels/sec
GeForce 8800 GS		26400 Mtexels/sec
	Difference: 13600 (52%)

Pixel Rate

If running with lots of anti-aliasing is important to you, then the Radeon R9 M380 is a better choice, by a large margin. (explain)

Radeon R9 M380		16000 Mpixels/sec
GeForce 8800 GS		6600 Mpixels/sec
	Difference: 9400 (142%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the max amount of data (measured in megabytes per second) that can be transported past the external memory interface within a second. The number is calculated by multiplying the card's bus width by the speed of its memory. If it uses DDR RAM, it must be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the faster the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions.

Texel Rate: Texel rate is the maximum texture map elements (texels) that are applied per second. This is worked out by multiplying the total amount of texture units by the core clock speed of the chip. The better this number, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in a second.

Pixel Rate: Pixel rate is the maximum number of pixels that the graphics chip could possibly write to its local memory in a second - measured in millions of pixels per second. The number is calculated by multiplying the number of Raster Operations Pipelines by the the core speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel fill rate is also dependant on lots of other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the ability to reach the maximum fill rate.