Compare any two graphics cards:
GeForce 920M vs Radeon HD 4870 1GB
IntroThe GeForce 920M features a GPU core clock speed of 954 MHz, and the 2048 MB of DDR3 RAM is set to run at 900 MHz through a 64-bit bus. It also features 384 SPUs, 32 TAUs, and 8 ROPs.Compare that to the Radeon HD 4870 1GB, which features a clock speed of 750 MHz and a GDDR5 memory frequency of 900 MHz. It also uses a 256-bit bus, and uses a 55 nm design. It features 800(160x5) SPUs, 40 Texture Address Units, and 16 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksMemory BandwidthAs far as performance goes, the Radeon HD 4870 1GB should theoretically be a lot better than the GeForce 920M overall. (explain)
Texel RateThe GeForce 920M should be a little bit (approximately 2%) faster with regards to anisotropic filtering than the Radeon HD 4870 1GB. (explain)
Pixel RateIf using high levels of AA is important to you, then the Radeon HD 4870 1GB is a better choice, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of data (measured in megabytes per second) that can be moved over the external memory interface within a second. It's calculated by multiplying the interface width by the speed of its memory. If it uses DDR memory, it must be multiplied by 2 once again. If DDR5, multiply by 4 instead. The better the bandwidth is, the faster the card will be in general. It especially helps with anti-aliasing, HDR and higher screen resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be processed in one second. This figure is worked out by multiplying the total amount of texture units by the core clock speed of the chip. The higher this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in one second. Pixel Rate: Pixel rate is the maximum amount of pixels the graphics card could possibly write to the local memory per second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the amount of ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate also depends on quite a few other factors, especially the memory bandwidth of the card - the lower the bandwidth is, the lower the ability to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!