Compare any two graphics cards:
GeForce 9500 GT DDR2 vs Geforce GTX 680
IntroThe GeForce 9500 GT DDR2 makes use of a 65 nm design. nVidia has set the core frequency at 550 MHz. The DDR2 memory is set to run at a frequency of 500 MHz on this model. It features 32 SPUs along with 16 TAUs and 8 ROPs.Compare those specs to the Geforce GTX 680, which comes with core clock speeds of 1006 MHz on the GPU, and 1502 MHz on the 2048 MB of GDDR5 RAM. It features 1536 SPUs as well as 128 TAUs and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthPerformance-wise, the Geforce GTX 680 should theoretically be much superior to the GeForce 9500 GT DDR2 in general. (explain)
Texel RateThe Geforce GTX 680 is a lot (about 1363%) faster with regards to AF than the GeForce 9500 GT DDR2. (explain)
Pixel RateIf running with a high screen resolution is important to you, then the Geforce GTX 680 is the winner, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the max amount of information (counted in MB per second) that can be transferred across the external memory interface within a second. The number is calculated by multiplying the card's bus width by its memory clock speed. If it uses DDR RAM, it must be multiplied by 2 again. If DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the better the card will be in general. It especially helps with AA, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are processed in one second. This figure is calculated by multiplying the total texture units by the core clock speed of the chip. The higher the texel rate, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second. Pixel Rate: Pixel rate is the most pixels the graphics card can possibly write to the local memory in a second - measured in millions of pixels per second. The figure is calculated by multiplying the number of colour ROPs by the the core speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate is also dependant on quite a few other factors, especially the memory bandwidth - the lower the bandwidth is, the lower the potential to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!