Compare any two graphics cards:
GeForce GTX 1050 Ti vs GeForce RTX 3050
IntroThe GeForce GTX 1050 Ti features a GPU clock speed of 1290 MHz, and the 4096 MB of GDDR5 memory is set to run at 1750 MHz through a 128-bit bus. It also is comprised of 768 Stream Processors, 48 TAUs, and 32 ROPs.Compare those specs to the GeForce RTX 3050, which makes use of a 8 nm design. nVidia has set the core speed at 1552 MHz. The GDDR6 RAM runs at a speed of 1750 MHz on this particular model. It features 2560 SPUs along with 80 TAUs and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce RTX 3050 will be 100% faster than the GeForce GTX 1050 Ti overall, because of its greater bandwidth. (explain)
Texel RateThe GeForce RTX 3050 should be much (more or less 101%) better at anisotropic filtering than the GeForce GTX 1050 Ti. (explain)
Pixel RateThe GeForce RTX 3050 will be a bit (approximately 20%) more effective at FSAA than the GeForce GTX 1050 Ti, and should be able to handle higher screen resolutions better. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of data (counted in megabytes per second) that can be transferred across the external memory interface in a second. The number is worked out by multiplying the card's bus width by its memory clock speed. If the card has DDR type memory, the result should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The higher the card's memory bandwidth, the better the card will be in general. It especially helps with AA, HDR and higher screen resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be applied per second. This figure is calculated by multiplying the total amount of texture units by the core clock speed of the chip. The higher this number, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second. Pixel Rate: Pixel rate is the maximum amount of pixels the graphics card could possibly record to its local memory per second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of Raster Operations Pipelines by the the core speed of the card. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel rate also depends on quite a few other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the ability to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!