Compare any two graphics cards:
GeForce GTX 780 Ti vs Radeon RX 6500 XT
IntroThe GeForce GTX 780 Ti comes with a GPU core clock speed of 875 MHz, and the 3072 MB of GDDR5 RAM is set to run at 1750 MHz through a 384-bit bus. It also is comprised of 2880 Stream Processors, 240 Texture Address Units, and 48 ROPs.Compare those specifications to the Radeon RX 6500 XT, which has core speeds of 2200 MHz on the GPU, and 2250 MHz on the 4096 MB of GDDR6 RAM. It features 1024 SPUs along with 64 TAUs and 32 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe GeForce GTX 780 Ti, in theory, should be quite a bit faster than the Radeon RX 6500 XT overall. (explain)
Texel RateThe GeForce GTX 780 Ti should be much (approximately 49%) better at AF than the Radeon RX 6500 XT. (explain)
Pixel RateIf using lots of anti-aliasing is important to you, then the Radeon RX 6500 XT is superior to the GeForce GTX 780 Ti, by far. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the maximum amount of data (in units of megabytes per second) that can be transported past the external memory interface in a second. The number is worked out by multiplying the card's bus width by its memory speed. In the case of DDR RAM, it must be multiplied by 2 once again. If DDR5, multiply by 4 instead. The better the card's memory bandwidth, the faster the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are applied per second. This figure is worked out by multiplying the total number of texture units of the card by the core clock speed of the chip. The better the texel rate, the better the video card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip can possibly write to its local memory per second - measured in millions of pixels per second. The number is calculated by multiplying the number of Raster Operations Pipelines by the clock speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate is also dependant on lots of other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the potential to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!