Compare any two graphics cards:
GeForce RTX 3060 vs Radeon RX 6600 XT
IntroThe GeForce RTX 3060 has a GPU clock speed of 1320 MHz, and the (Unknown) MB of GDDR6 memory is set to run at 1875 MHz through a 192-bit bus. It also features 3584 Stream Processors, 112 Texture Address Units, and 48 Raster Operation Units.Compare that to the Radeon RX 6600 XT, which comes with GPU core speed of 1968 MHz, and 8192 MB of GDDR6 memory set to run at 2000 MHz through a 128-bit bus. It also is made up of 2048 SPUs, 128 TAUs, and 64 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically, the GeForce RTX 3060 should be a lot faster than the Radeon RX 6600 XT in general. (explain)
Texel RateThe Radeon RX 6600 XT will be a lot (approximately 70%) faster with regards to texture filtering than the GeForce RTX 3060. (explain)
Pixel RateThe Radeon RX 6600 XT is quite a bit (about 99%) better at anti-aliasing than the GeForce RTX 3060, and also able to handle higher screen resolutions while still performing well. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of information (in units of MB per second) that can be transported over the external memory interface within a second. It's worked out by multiplying the interface width by its memory clock speed. If it uses DDR type memory, it should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The higher the memory bandwidth, the faster the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be processed in one second. This figure is worked out by multiplying the total amount of texture units by the core clock speed of the chip. The better the texel rate, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in one second. Pixel Rate: Pixel rate is the most pixels that the graphics chip could possibly write to the local memory in a second - measured in millions of pixels per second. Pixel rate is worked out by multiplying the amount of colour ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate is also dependant on quite a few other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the potential to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!