Compare any two graphics cards:
Radeon R9 M370X vs Radeon RX 6900 XT
IntroThe Radeon R9 M370X has a clock frequency of 800 MHz and a GDDR5 memory frequency of 1125 MHz. It also uses a 128-bit memory bus, and uses a 28 nm design. It is made up of 640 SPUs, 40 Texture Address Units, and 16 Raster Operation Units.Compare all that to the Radeon RX 6900 XT, which has a GPU core clock speed of 1825 MHz, and 16384 MB of GDDR6 memory set to run at 2000 MHz through a 256-bit bus. It also is made up of 5120 SPUs, 320 TAUs, and 128 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksMemory BandwidthThe Radeon RX 6900 XT, in theory, should be much faster than the Radeon R9 M370X overall. (explain)
Texel RateThe Radeon RX 6900 XT is much (approximately 1725%) faster with regards to anisotropic filtering than the Radeon R9 M370X. (explain)
Pixel RateIf using a high resolution is important to you, then the Radeon RX 6900 XT is the winner, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the maximum amount of data (measured in megabytes per second) that can be transported over the external memory interface within a second. It is worked out by multiplying the card's interface width by its memory speed. If it uses DDR type RAM, the result should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The higher the memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, HDR and higher screen resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be processed in one second. This figure is calculated by multiplying the total amount of texture units by the core speed of the chip. The higher this number, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics card can possibly record to the local memory per second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel fill rate also depends on lots of other factors, most notably the memory bandwidth - the lower the memory bandwidth is, the lower the potential to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!