Compare any two graphics cards:
Radeon HD 6770 1GB vs Radeon RX 550
IntroThe Radeon HD 6770 1GB makes use of a 40 nm design. AMD has set the core frequency at 900 MHz. The GDDR5 RAM is set to run at a speed of 1050 MHz on this particular card. It features 800 SPUs as well as 40 Texture Address Units and 16 ROPs.Compare those specifications to the Radeon RX 550, which comes with GPU clock speed of 1100 MHz, and 2048 MB of GDDR5 memory running at 1750 MHz through a 128-bit bus. It also features 512 Stream Processors, 32 TAUs, and 16 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthIn theory, the Radeon RX 550 will be 71% faster than the Radeon HD 6770 1GB overall, because of its greater data rate. (explain)
Texel RateThe Radeon HD 6770 1GB should be a little bit (approximately 2%) faster with regards to anisotropic filtering than the Radeon RX 550. (explain)
Pixel RateThe Radeon RX 550 is a lot (approximately 22%) more effective at anti-aliasing than the Radeon HD 6770 1GB, and able to handle higher resolutions more effectively. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (in units of megabytes per second) that can be transferred across the external memory interface in a second. It is worked out by multiplying the bus width by its memory clock speed. In the case of DDR memory, it should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The higher the bandwidth is, the better the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be applied in one second. This number is worked out by multiplying the total texture units of the card by the core clock speed of the chip. The better this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in a second. Pixel Rate: Pixel rate is the maximum number of pixels the video card could possibly write to the local memory per second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of Render Output Units by the the card's clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel output rate also depends on quite a few other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!