Compare any two graphics cards:
GeForce GT 430 1GB vs Radeon RX 470 4GB
IntroThe GeForce GT 430 1GB comes with a GPU core clock speed of 700 MHz, and the 1024 MB of GDDR3 memory is set to run at 900 MHz through a 128-bit bus. It also features 96 Stream Processors, 16 Texture Address Units, and 4 ROPs.Compare all of that to the Radeon RX 470 4GB, which comes with core clock speeds of 926 MHz on the GPU, and 1650 MHz on the 4096 MB of GDDR5 RAM. It features 2048 SPUs as well as 128 TAUs and 32 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthPerformance-wise, the Radeon RX 470 4GB should theoretically be much better than the GeForce GT 430 1GB in general. (explain)
Texel RateThe Radeon RX 470 4GB is much (about 958%) faster with regards to anisotropic filtering than the GeForce GT 430 1GB. (explain)
Pixel RateIf using a high resolution is important to you, then the Radeon RX 470 4GB is the winner, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (measured in MB per second) that can be transported past the external memory interface in a second. It is calculated by multiplying the bus width by the speed of its memory. If the card has DDR RAM, it must be multiplied by 2 once again. If it uses DDR5, multiply by ANOTHER 2x. The higher the bandwidth is, the faster the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be applied per second. This is worked out by multiplying the total number of texture units by the core clock speed of the chip. The higher the texel rate, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip can possibly write to the local memory in one second - measured in millions of pixels per second. The number is worked out by multiplying the number of Raster Operations Pipelines by the clock speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel fill rate is also dependant on lots of other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the potential to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!