Compare any two graphics cards:
GeForce GTX 1060 3GB vs Radeon HD 5750 1GB
IntroThe GeForce GTX 1060 3GB features a GPU clock speed of 1506 MHz, and the 3072 MB of GDDR5 RAM runs at 2000 MHz through a 192-bit bus. It also is made up of 1152 SPUs, 72 Texture Address Units, and 48 ROPs.Compare all that to the Radeon HD 5750 1GB, which has core clock speeds of 700 MHz on the GPU, and 1150 MHz on the 1024 MB of GDDR5 memory. It features 720(144x5) SPUs along with 36 Texture Address Units and 16 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 1060 3GB should perform quite a bit faster than the Radeon HD 5750 1GB in general. (explain)
Texel RateThe GeForce GTX 1060 3GB should be much (approximately 330%) better at anisotropic filtering than the Radeon HD 5750 1GB. (explain)
Pixel RateThe GeForce GTX 1060 3GB will be much (about 545%) faster with regards to FSAA than the Radeon HD 5750 1GB, and also will be able to handle higher screen resolutions better. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the maximum amount of information (measured in megabytes per second) that can be transferred over the external memory interface in a second. It is calculated by multiplying the card's interface width by the speed of its memory. In the case of DDR memory, it should be multiplied by 2 once again. If DDR5, multiply by ANOTHER 2x. The better the card's memory bandwidth, the faster the card will be in general. It especially helps with AA, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be applied per second. This figure is worked out by multiplying the total amount of texture units by the core speed of the chip. The better this number, the better the video card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in one second. Pixel Rate: Pixel rate is the maximum number of pixels the graphics card can possibly record to its local memory in one second - measured in millions of pixels per second. The figure is worked out by multiplying the number of Render Output Units by the clock speed of the card. ROPs (Raster Operations Pipelines - also called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel output rate also depends on lots of other factors, most notably the memory bandwidth - the lower the memory bandwidth is, the lower the potential to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!