Compare any two graphics cards:
GeForce GTX 1060 3GB vs Radeon HD 6750
IntroThe GeForce GTX 1060 3GB has a GPU core speed of 1506 MHz, and the 3072 MB of GDDR5 RAM is set to run at 2000 MHz through a 192-bit bus. It also features 1152 SPUs, 72 TAUs, and 48 ROPs.Compare those specs to the Radeon HD 6750, which has a GPU core clock speed of 725 MHz, and 512 MB of GDDR5 RAM set to run at 1000 MHz through a 128-bit bus. It also features 720 Stream Processors, 36 Texture Address Units, and 16 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 1060 3GB should be much faster than the Radeon HD 6750 overall. (explain)
Texel RateThe GeForce GTX 1060 3GB should be a lot (about 315%) more effective at AF than the Radeon HD 6750. (explain)
Pixel RateIf using a high screen resolution is important to you, then the GeForce GTX 1060 3GB is superior to the Radeon HD 6750, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (counted in MB per second) that can be moved across the external memory interface in one second. It's calculated by multiplying the bus width by its memory clock speed. If it uses DDR type memory, the result should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the faster the card will be in general. It especially helps with AA, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are processed in one second. This is worked out by multiplying the total amount of texture units of the card by the core clock speed of the chip. The better this number, the better the video card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip can possibly record to the local memory in a second - measured in millions of pixels per second. The figure is worked out by multiplying the number of ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel rate also depends on lots of other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the ability to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!