GeForce GTX 560 vs Radeon R9 M380

Intro

Compare those specs to the Radeon R9 M380, which features clock speeds of 1000 MHz on the GPU, and 1500 MHz on the 4096 MB of GDDR5 RAM. It features 640 SPUs as well as 40 Texture Address Units and 16 Rasterization Operator Units.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Memory Bandwidth

The GeForce GTX 560 should theoretically be a lot faster than the Radeon R9 M380 in general. (explain)

GeForce GTX 560		128128 MB/sec
Radeon R9 M380		96000 MB/sec
	Difference: 32128 (33%)

Texel Rate

The GeForce GTX 560 will be a little bit (approximately 13%) better at texture filtering than the Radeon R9 M380. (explain)

GeForce GTX 560		45360 Mtexels/sec
Radeon R9 M380		40000 Mtexels/sec
	Difference: 5360 (13%)

Pixel Rate

If running with high levels of AA is important to you, then the GeForce GTX 560 is the winner, by far. (explain)

GeForce GTX 560		25920 Mpixels/sec
Radeon R9 M380		16000 Mpixels/sec
	Difference: 9920 (62%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the largest amount of data (in units of megabytes per second) that can be transported over the external memory interface within a second. It's calculated by multiplying the card's interface width by the speed of its memory. If the card has DDR memory, the result should be multiplied by 2 once again. If DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and higher screen resolutions.

Texel Rate: Texel rate is the maximum texture map elements (texels) that are processed per second. This figure is worked out by multiplying the total texture units by the core clock speed of the chip. The better this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second.

Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip can possibly record to the local memory in a second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the amount of Raster Operations Pipelines by the the card's clock speed. ROPs (Raster Operations Pipelines - also called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate also depends on lots of other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to get to the max fill rate.