Compare any two graphics cards:
GeForce 9600 GT 512MB vs Radeon R7 M360
IntroThe GeForce 9600 GT 512MB features a GPU core speed of 650 MHz, and the 512 MB of GDDR3 memory runs at 900 MHz through a 256-bit bus. It also features 64 Stream Processors, 32 Texture Address Units, and 16 ROPs.Compare all of that to the Radeon R7 M360, which features core clock speeds of 1125 MHz on the GPU, and 1000 MHz on the 2048 MB of DDR3 memory. It features 384 SPUs along with 24 TAUs and 8 Rasterization Operator Units.
Display Graphs
Power Usage and Theoretical BenchmarksMemory BandwidthPerformance-wise, the GeForce 9600 GT 512MB should in theory be a lot better than the Radeon R7 M360 in general. (explain)
Texel RateThe Radeon R7 M360 should be a lot (approximately 30%) faster with regards to anisotropic filtering than the GeForce 9600 GT 512MB. (explain)
Pixel RateIf using lots of anti-aliasing is important to you, then the GeForce 9600 GT 512MB is a better choice, but it probably won't make a huge difference. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of information (counted in megabytes per second) that can be transferred across the external memory interface in one second. It is worked out by multiplying the bus width by its memory speed. If it uses DDR type memory, the result should be multiplied by 2 again. If DDR5, multiply by 4 instead. The higher the card's memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be applied in one second. This number is calculated by multiplying the total amount of texture units of the card by the core clock speed of the chip. The better this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in one second. Pixel Rate: Pixel rate is the most pixels that the graphics card can possibly write to its local memory per second - measured in millions of pixels per second. The number is calculated by multiplying the amount of ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel rate also depends on lots of other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!