Compare any two graphics cards:
GeForce GTX 560 Ti vs Radeon R7 M360
IntroThe GeForce GTX 560 Ti features a GPU clock speed of 822 MHz, and the 1024 MB of GDDR5 memory runs at 1002 MHz through a 256-bit bus. It also is made up of 384 SPUs, 64 Texture Address Units, and 32 ROPs.Compare all of that to the Radeon R7 M360, which has a core clock speed of 1125 MHz and a DDR3 memory frequency of 1000 MHz. It also features a 64-bit memory bus, and makes use of a 28 nm design. It is comprised of 384 SPUs, 24 TAUs, and 8 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksMemory BandwidthIn theory, the GeForce GTX 560 Ti should be 702% quicker than the Radeon R7 M360 in general, because of its higher bandwidth. (explain)
Texel RateThe GeForce GTX 560 Ti is a lot (approximately 95%) faster with regards to anisotropic filtering than the Radeon R7 M360. (explain)
Pixel RateThe GeForce GTX 560 Ti is a lot (about 192%) faster with regards to AA than the Radeon R7 M360, and also will be able to handle higher resolutions while still performing well. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (measured in megabytes per second) that can be transferred past the external memory interface in a second. It is calculated by multiplying the card's bus width by its memory clock speed. In the case of DDR RAM, it must be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The better the bandwidth is, the faster the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are processed in one second. This number is worked out by multiplying the total amount of texture units of the card by the core speed of the chip. The higher this number, the better the video card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip could possibly write to the local memory per second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the number of Render Output Units by the the core speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel rate also depends on quite a few other factors, especially the memory bandwidth of the card - the lower the bandwidth is, the lower the ability to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!