Compare any two graphics cards:
GeForce GT 430 (OEM) vs GeForce GTX 880M
IntroThe GeForce GT 430 (OEM) features clock speeds of 700 MHz on the GPU, and 900 MHz on the 2048 MB of GDDR3 memory. It features 96 SPUs along with 16 Texture Address Units and 4 ROPs.Compare those specs to the GeForce GTX 880M, which features core clock speeds of 954 MHz on the GPU, and 1000 MHz on the 4096 MB of GDDR5 memory. It features 1536 SPUs as well as 128 TAUs and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 880M should be much faster than the GeForce GT 430 (OEM) overall. (explain)
Texel RateThe GeForce GTX 880M is a lot (approximately 990%) better at texture filtering than the GeForce GT 430 (OEM). (explain)
Pixel RateIf running with high levels of AA is important to you, then the GeForce GTX 880M is superior to the GeForce GT 430 (OEM), by a large margin. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of information (counted in MB per second) that can be transported over the external memory interface within a second. It is worked out by multiplying the card's bus width by its memory speed. If it uses DDR type memory, it should be multiplied by 2 again. If DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the faster the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are processed in one second. This figure is calculated by multiplying the total number of texture units by the core clock speed of the chip. The higher the texel rate, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in a second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip can possibly write to the local memory per second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate also depends on many other factors, especially the memory bandwidth - the lower the bandwidth is, the lower the ability to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!