Compare any two graphics cards:
GeForce GTX 260 Core 216 vs Radeon R9 M295X
IntroThe GeForce GTX 260 Core 216 features core clock speeds of 576 MHz on the GPU, and 999 MHz on the 896 MB of GDDR3 memory. It features 216 SPUs as well as 72 TAUs and 28 ROPs.Compare that to the Radeon R9 M295X, which has GPU core speed of 750 MHz, and 4096 MB of GDDR5 memory set to run at 1375 MHz through a 256-bit bus. It also features 2048 Stream Processors, 128 TAUs, and 32 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon R9 M295X should theoretically be a lot faster than the GeForce GTX 260 Core 216 overall. (explain)
Texel RateThe Radeon R9 M295X will be quite a bit (about 131%) faster with regards to anisotropic filtering than the GeForce GTX 260 Core 216. (explain)
Pixel RateIf using high levels of AA is important to you, then the Radeon R9 M295X is the winner, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the max amount of data (in units of megabytes per second) that can be transported past the external memory interface in one second. It's calculated by multiplying the card's interface width by the speed of its memory. If it uses DDR type memory, it must be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The better the memory bandwidth, the faster the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be processed in one second. This is worked out by multiplying the total amount of texture units of the card by the core clock speed of the chip. The higher this number, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in a second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip could possibly write to the local memory in a second - measured in millions of pixels per second. The number is worked out by multiplying the number of ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel rate also depends on lots of other factors, most notably the memory bandwidth of the card - the lower the bandwidth is, the lower the potential to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!