Compare any two graphics cards:
Radeon HD 5750 1GB vs Radeon R9 M290X
IntroThe Radeon HD 5750 1GB has a GPU core speed of 700 MHz, and the 1024 MB of GDDR5 memory runs at 1150 MHz through a 128-bit bus. It also is made up of 720(144x5) Stream Processors, 36 Texture Address Units, and 16 Raster Operation Units.Compare that to the Radeon R9 M290X, which comes with a clock speed of 850 MHz and a GDDR5 memory speed of 1200 MHz. It also makes use of a 256-bit memory bus, and uses a 28 nm design. It is made up of 1280 SPUs, 80 Texture Address Units, and 32 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthIn theory, the Radeon R9 M290X should be quite a bit faster than the Radeon HD 5750 1GB overall. (explain)
Texel RateThe Radeon R9 M290X should be a lot (more or less 170%) more effective at texture filtering than the Radeon HD 5750 1GB. (explain)
Pixel RateIf using high levels of AA is important to you, then the Radeon R9 M290X is a better choice, by far. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the max amount of data (counted in MB per second) that can be transferred over the external memory interface in one second. It is worked out by multiplying the card's bus width by the speed of its memory. In the case of DDR memory, it should be multiplied by 2 again. If DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be processed per second. This number is worked out by multiplying the total number of texture units by the core clock speed of the chip. The higher the texel rate, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed per second. Pixel Rate: Pixel rate is the most pixels that the graphics chip can possibly write to the local memory in one second - measured in millions of pixels per second. The figure is calculated by multiplying the number of Raster Operations Pipelines by the the core clock speed. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate also depends on quite a few other factors, most notably the memory bandwidth - the lower the memory bandwidth is, the lower the potential to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!