Compare any two graphics cards:
GeForce GT 440 3GB vs GeForce GTX 960M
IntroThe GeForce GT 440 3GB features a core clock frequency of 594 MHz and a GDDR3 memory speed of 900 MHz. It also uses a 192-bit bus, and uses a 40 nm design. It is comprised of 144 SPUs, 24 Texture Address Units, and 24 ROPs.Compare those specs to the GeForce GTX 960M, which comes with GPU clock speed of 1096 MHz, and 2048 MB of GDDR5 RAM running at 1000 MHz through a 128-bit bus. It also features 640 Stream Processors, 40 TAUs, and 16 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 960M should be a lot faster than the GeForce GT 440 3GB overall. (explain)
Texel RateThe GeForce GTX 960M will be much (approximately 208%) better at anisotropic filtering than the GeForce GT 440 3GB. (explain)
Pixel RateIf using lots of anti-aliasing is important to you, then the GeForce GTX 960M is a better choice, by far. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the maximum amount of data (measured in MB per second) that can be moved across the external memory interface within a second. It is calculated by multiplying the card's interface width by its memory clock speed. In the case of DDR type RAM, it should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The higher the memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are processed per second. This number is calculated by multiplying the total number of texture units of the card by the core speed of the chip. The higher the texel rate, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in one second. Pixel Rate: Pixel rate is the most pixels that the graphics chip could possibly write to its local memory in one second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate is also dependant on lots of other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the ability to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!