Compare any two graphics cards:
Radeon HD 6770 vs Radeon R7 260X
IntroThe Radeon HD 6770 features a GPU core clock speed of 900 MHz, and the 512 MB of GDDR5 RAM is set to run at 1050 MHz through a 128-bit bus. It also features 800 SPUs, 40 TAUs, and 16 ROPs.Compare those specifications to the Radeon R7 260X, which features a clock speed of 1100 MHz and a GDDR5 memory frequency of 1625 MHz. It also features a 128-bit bus, and uses a 28 nm design. It is comprised of 896 SPUs, 56 TAUs, and 16 ROPs.
Display Graphs
BenchmarksThese are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.
3DMark Fire Strike Graphics Score
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon R7 260X should theoretically perform much faster than the Radeon HD 6770 in general. (explain)
Texel RateThe Radeon R7 260X is much (about 71%) better at texture filtering than the Radeon HD 6770. (explain)
Pixel RateThe Radeon R7 260X should be a lot (more or less 22%) better at FSAA than the Radeon HD 6770, and also should be able to handle higher resolutions without slowing down too much. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (in units of megabytes per second) that can be transported over the external memory interface in one second. It's worked out by multiplying the bus width by the speed of its memory. In the case of DDR type RAM, the result should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The higher the bandwidth is, the faster the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are applied per second. This is worked out by multiplying the total amount of texture units by the core clock speed of the chip. The better this number, the better the video card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in a second. Pixel Rate: Pixel rate is the most pixels the video card could possibly write to its local memory per second - measured in millions of pixels per second. Pixel rate is worked out by multiplying the amount of Raster Operations Pipelines by the the card's clock speed. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel rate is also dependant on quite a few other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the potential to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!