Compare any two graphics cards:
GeForce 8400 GS 512MB vs Radeon HD 5770
IntroThe GeForce 8400 GS 512MB features a GPU clock speed of 650 MHz, and the 512 MB of DDR2 RAM is set to run at 400 MHz through a 64-bit bus. It also features 16 Stream Processors, 8 Texture Address Units, and 4 ROPs.Compare that to the Radeon HD 5770, which features core speeds of 850 MHz on the GPU, and 1200 MHz on the 1024 MB of GDDR5 memory. It features 800(160x5) SPUs as well as 40 TAUs and 16 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthPerformance-wise, the Radeon HD 5770 should theoretically be a lot better than the GeForce 8400 GS 512MB in general. (explain)
Texel RateThe Radeon HD 5770 should be a lot (about 554%) better at texture filtering than the GeForce 8400 GS 512MB. (explain)
Pixel RateThe Radeon HD 5770 will be quite a bit (approximately 423%) faster with regards to anti-aliasing than the GeForce 8400 GS 512MB, and also capable of handling higher screen resolutions without slowing down too much. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the max amount of data (counted in MB per second) that can be transferred past the external memory interface in one second. It is calculated by multiplying the interface width by its memory speed. If the card has DDR memory, the result should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The higher the bandwidth is, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are applied per second. This figure is calculated by multiplying the total texture units by the core clock speed of the chip. The higher the texel rate, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second. Pixel Rate: Pixel rate is the maximum number of pixels that the graphics card can possibly record to its local memory in one second - measured in millions of pixels per second. The number is calculated by multiplying the amount of colour ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel output rate is also dependant on quite a few other factors, most notably the memory bandwidth of the card - the lower the bandwidth is, the lower the ability to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!