GeForce RTX 3080 Ti vs Radeon RX 480

Intro

The GeForce RTX 3080 Ti comes with a core clock frequency of 1365 MHz and a GDDR6X memory speed of 1188 MHz. It also makes use of a 384-bit memory bus, and makes use of a 8 nm design. It is made up of 10240 SPUs, 320 Texture Address Units, and 112 Raster Operation Units.

Compare all of that to the Radeon RX 480, which has a GPU core clock speed of 1120 MHz, and 8192 MB of GDDR5 RAM set to run at 2000 MHz through a 256-bit bus. It also is made up of 2304 Stream Processors, 144 TAUs, and 32 Raster Operation Units.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of data (measured in megabytes per second) that can be transferred over the external memory interface in a second. The number is calculated by multiplying the bus width by the speed of its memory. In the case of DDR type RAM, the result should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, HDR and higher screen resolutions.

Texel Rate: Texel rate is the maximum texture map elements (texels) that are applied per second. This is worked out by multiplying the total number of texture units by the core clock speed of the chip. The better the texel rate, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second.

Pixel Rate: Pixel rate is the most pixels the graphics card can possibly record to the local memory per second - measured in millions of pixels per second. The figure is worked out by multiplying the number of ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate also depends on quite a few other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the ability to get to the maximum fill rate.