GeForce GTX 650 Ti 2GB vs Radeon RX 5700 XT

Intro

Compare that to the Radeon RX 5700 XT, which features GPU clock speed of 1605 MHz, and 8096 MB of GDDR6 RAM running at 1750 MHz through a 256-bit bus. It also is made up of 2560 Stream Processors, 160 TAUs, and 64 Raster Operation Units.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce GTX 650 Ti 2GB		110 Watts
Radeon RX 5700 XT		225 Watts
	Difference: 115 Watts (105%)

Memory Bandwidth

In theory, the Radeon RX 5700 XT will be 431% faster than the GeForce GTX 650 Ti 2GB overall, due to its greater bandwidth. (explain)

Radeon RX 5700 XT		458752 MB/sec
GeForce GTX 650 Ti 2GB		86400 MB/sec
	Difference: 372352 (431%)

Texel Rate

The Radeon RX 5700 XT should be a lot (about 332%) faster with regards to texture filtering than the GeForce GTX 650 Ti 2GB. (explain)

Radeon RX 5700 XT		256800 Mtexels/sec
GeForce GTX 650 Ti 2GB		59392 Mtexels/sec
	Difference: 197408 (332%)

Pixel Rate

If using high levels of AA is important to you, then the Radeon RX 5700 XT is the winner, and very much so. (explain)

Radeon RX 5700 XT		102720 Mpixels/sec
GeForce GTX 650 Ti 2GB		14848 Mpixels/sec
	Difference: 87872 (592%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of information (counted in megabytes per second) that can be transported past the external memory interface within a second. It's worked out by multiplying the bus width by the speed of its memory. If it uses DDR type RAM, it must be multiplied by 2 once again. If it uses DDR5, multiply by ANOTHER 2x. The higher the bandwidth is, the faster the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions.

Texel Rate: Texel rate is the maximum texture map elements (texels) that can be applied in one second. This figure is worked out by multiplying the total number of texture units by the core clock speed of the chip. The higher this number, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second.

Pixel Rate: Pixel rate is the most pixels that the graphics chip could possibly write to the local memory in one second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of colour ROPs by the the core speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel rate is also dependant on quite a few other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the ability to reach the max fill rate.