GeForce GTX 1050 Ti vs GeForce GTX 780 Ti

Intro

Compare all that to the GeForce GTX 780 Ti, which comes with GPU core speed of 875 MHz, and 3072 MB of GDDR5 memory set to run at 1750 MHz through a 384-bit bus. It also is comprised of 2880 SPUs, 240 Texture Address Units, and 48 ROPs.

Display Graphs

Hide Graphs

Benchmarks

These are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.

3DMark Fire Strike Graphics Score

GeForce GTX 780 Ti		10900 points
GeForce GTX 1050 Ti		7734 points
	Difference: 3166 (41%)

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce GTX 1050 Ti		75 Watts
GeForce GTX 780 Ti		250 Watts
	Difference: 175 Watts (233%)

Memory Bandwidth

The GeForce GTX 780 Ti should theoretically perform a lot faster than the GeForce GTX 1050 Ti overall. (explain)

GeForce GTX 780 Ti		336000 MB/sec
GeForce GTX 1050 Ti		114688 MB/sec
	Difference: 221312 (193%)

Texel Rate

The GeForce GTX 780 Ti should be a lot (approximately 239%) faster with regards to texture filtering than the GeForce GTX 1050 Ti. (explain)

GeForce GTX 780 Ti		210000 Mtexels/sec
GeForce GTX 1050 Ti		61920 Mtexels/sec
	Difference: 148080 (239%)

Pixel Rate

If using high levels of AA is important to you, then the GeForce GTX 780 Ti is a better choice, but not by far. (explain)

GeForce GTX 780 Ti		42000 Mpixels/sec
GeForce GTX 1050 Ti		41280 Mpixels/sec
	Difference: 720 (2%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the largest amount of data (measured in MB per second) that can be transferred past the external memory interface in one second. It's calculated by multiplying the card's bus width by its memory speed. In the case of DDR memory, the result should be multiplied by 2 once again. If DDR5, multiply by 4 instead. The better the bandwidth is, the faster the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions.

Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are processed per second. This figure is calculated by multiplying the total amount of texture units of the card by the core speed of the chip. The higher the texel rate, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in one second.

Pixel Rate: Pixel rate is the maximum amount of pixels the video card could possibly record to its local memory in a second - measured in millions of pixels per second. The figure is worked out by multiplying the number of ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel rate is also dependant on lots of other factors, most notably the memory bandwidth - the lower the memory bandwidth is, the lower the potential to get to the maximum fill rate.