Radeon R9 M375 vs Radeon R9 M375X

Intro

Compare all of that to the Radeon R9 M375X, which has a clock frequency of 1015 MHz and a GDDR5 memory frequency of 1125 MHz. It also makes use of a 128-bit memory bus, and uses a 28 nm design. It features 640 SPUs, 40 Texture Address Units, and 16 Raster Operation Units.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Memory Bandwidth

In theory, the Radeon R9 M375X should be 105% faster than the Radeon R9 M375 overall, due to its greater data rate. (explain)

Radeon R9 M375X		72000 MB/sec
Radeon R9 M375		35200 MB/sec
	Difference: 36800 (105%)

Texel Rate

Both cards have exactly the same texel rate, so theoretically they should be equally good at at anisotropic filtering. (explain)

Pixel Rate

Both cards have exactly the same pixel fill rate, so in theory they should be equally good at at full screen anti-aliasing, and be able to handle the same resolutions. (explain)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of data (counted in MB per second) that can be transported across the external memory interface in one second. It is calculated by multiplying the interface width by its memory clock speed. If the card has DDR type memory, the result should be multiplied by 2 again. If DDR5, multiply by ANOTHER 2x. The better the bandwidth is, the better the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions.

Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are applied per second. This figure is calculated by multiplying the total amount of texture units of the card by the core clock speed of the chip. The higher this number, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second.

Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics chip can possibly record to the local memory per second - measured in millions of pixels per second. The number is worked out by multiplying the amount of colour ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - also called Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate also depends on quite a few other factors, especially the memory bandwidth - the lower the bandwidth is, the lower the potential to reach the max fill rate.