GeForce GTX 1070 Ti vs Radeon R9 Fury X

Intro

Compare those specifications to the Radeon R9 Fury X, which comes with a core clock speed of 1050 MHz and a HBM memory frequency of 500 MHz. It also uses a 4096-bit memory bus, and makes use of a 28 nm design. It features 4096 SPUs, 256 TAUs, and 64 Raster Operation Units.

Display Graphs

Hide Graphs

Benchmarks

These are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.

3DMark Fire Strike Graphics Score

GeForce GTX 1070 Ti		19808 points
Radeon R9 Fury X		14793 points
	Difference: 5015 (34%)

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce GTX 1070 Ti		180 Watts
Radeon R9 Fury X		275 Watts
	Difference: 95 Watts (53%)

Memory Bandwidth

Theoretically speaking, the Radeon R9 Fury X should be 95% faster than the GeForce GTX 1070 Ti in general, due to its greater bandwidth. (explain)

Radeon R9 Fury X		512000 MB/sec
GeForce GTX 1070 Ti		262144 MB/sec
	Difference: 249856 (95%)

Texel Rate

The Radeon R9 Fury X is a little bit (about 10%) better at texture filtering than the GeForce GTX 1070 Ti. (explain)

Radeon R9 Fury X		268800 Mtexels/sec
GeForce GTX 1070 Ti		244264 Mtexels/sec
	Difference: 24536 (10%)

Pixel Rate

The GeForce GTX 1070 Ti should be much (more or less 53%) more effective at FSAA than the Radeon R9 Fury X, and also should be able to handle higher screen resolutions without slowing down too much. (explain)

GeForce GTX 1070 Ti		102848 Mpixels/sec
Radeon R9 Fury X		67200 Mpixels/sec
	Difference: 35648 (53%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of information (measured in MB per second) that can be transferred across the external memory interface in one second. It's calculated by multiplying the card's interface width by its memory speed. In the case of DDR type RAM, the result should be multiplied by 2 once again. If DDR5, multiply by 4 instead. The higher the bandwidth is, the better the card will be in general. It especially helps with AA, HDR and higher screen resolutions.

Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be applied in one second. This number is worked out by multiplying the total texture units by the core clock speed of the chip. The better this number, the better the video card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second.

Pixel Rate: Pixel rate is the maximum number of pixels the video card could possibly record to its local memory in a second - measured in millions of pixels per second. The number is worked out by multiplying the amount of Render Output Units by the the core clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate also depends on quite a few other factors, especially the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to get to the maximum fill rate.