GeForce GTX 1070 Ti vs Radeon R9 M375X

Intro

Compare those specifications to the Radeon R9 M375X, which makes use of a 28 nm design. AMD has set the core frequency at 1015 MHz. The GDDR5 memory is set to run at a frequency of 1125 MHz on this card. It features 640 SPUs as well as 40 Texture Address Units and 16 ROPs.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Memory Bandwidth

As far as performance goes, the GeForce GTX 1070 Ti should in theory be much better than the Radeon R9 M375X overall. (explain)

GeForce GTX 1070 Ti		262144 MB/sec
Radeon R9 M375X		72000 MB/sec
	Difference: 190144 (264%)

Texel Rate

The GeForce GTX 1070 Ti will be much (approximately 502%) more effective at anisotropic filtering than the Radeon R9 M375X. (explain)

GeForce GTX 1070 Ti		244264 Mtexels/sec
Radeon R9 M375X		40600 Mtexels/sec
	Difference: 203664 (502%)

Pixel Rate

The GeForce GTX 1070 Ti should be quite a bit (more or less 533%) faster with regards to AA than the Radeon R9 M375X, and should be able to handle higher screen resolutions without slowing down too much. (explain)

GeForce GTX 1070 Ti		102848 Mpixels/sec
Radeon R9 M375X		16240 Mpixels/sec
	Difference: 86608 (533%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of information (counted in MB per second) that can be moved past the external memory interface in a second. The number is worked out by multiplying the bus width by the speed of its memory. If the card has DDR type RAM, it should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The higher the bandwidth is, the faster the card will be in general. It especially helps with AA, HDR and higher screen resolutions.

Texel Rate: Texel rate is the maximum texture map elements (texels) that are applied per second. This is worked out by multiplying the total texture units by the core speed of the chip. The higher this number, the better the video card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in a second.

Pixel Rate: Pixel rate is the maximum number of pixels the graphics card can possibly write to the local memory per second - measured in millions of pixels per second. Pixel rate is worked out by multiplying the number of Raster Operations Pipelines by the the core speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel fill rate is also dependant on quite a few other factors, most notably the memory bandwidth of the card - the lower the bandwidth is, the lower the ability to reach the maximum fill rate.