GeForce GT 240 GDDR5 1GB vs Radeon R7 250X 2GB

Intro

Compare those specs to the Radeon R7 250X 2GB, which features GPU clock speed of 1000 MHz, and 2048 MB of GDDR5 RAM set to run at 1125 MHz through a 128-bit bus. It also features 640 Stream Processors, 40 Texture Address Units, and 16 ROPs.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce GT 240 GDDR5 1GB		70 Watts
Radeon R7 250X 2GB		95 Watts
	Difference: 25 Watts (36%)

Memory Bandwidth

Theoretically speaking, the Radeon R7 250X 2GB should be 32% faster than the GeForce GT 240 GDDR5 1GB overall, due to its greater bandwidth. (explain)

Radeon R7 250X 2GB		72000 MB/sec
GeForce GT 240 GDDR5 1GB		54400 MB/sec
	Difference: 17600 (32%)

Texel Rate

The Radeon R7 250X 2GB should be a lot (approximately 127%) better at anisotropic filtering than the GeForce GT 240 GDDR5 1GB. (explain)

Radeon R7 250X 2GB		40000 Mtexels/sec
GeForce GT 240 GDDR5 1GB		17600 Mtexels/sec
	Difference: 22400 (127%)

Pixel Rate

The Radeon R7 250X 2GB will be much (approximately 264%) more effective at anti-aliasing than the GeForce GT 240 GDDR5 1GB, and also will be able to handle higher resolutions without losing too much performance. (explain)

Radeon R7 250X 2GB		16000 Mpixels/sec
GeForce GT 240 GDDR5 1GB		4400 Mpixels/sec
	Difference: 11600 (264%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the largest amount of data (counted in megabytes per second) that can be transported over the external memory interface in a second. The number is calculated by multiplying the bus width by its memory clock speed. In the case of DDR memory, it must be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The better the card's memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, HDR and higher screen resolutions.

Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be processed in one second. This is worked out by multiplying the total texture units of the card by the core speed of the chip. The higher this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in one second.

Pixel Rate: Pixel rate is the most pixels that the graphics chip could possibly write to the local memory in a second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the number of ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate also depends on quite a few other factors, especially the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to reach the max fill rate.