GeForce GTX 650 Ti 2GB vs Radeon HD 4850 512MB

Intro

Compare those specifications to the Radeon HD 4850 512MB, which comes with core speeds of 625 MHz on the GPU, and 993 MHz on the 512 MB of GDDR3 RAM. It features 800(160x5) SPUs along with 40 Texture Address Units and 16 Rasterization Operator Units.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Both cards have the same power consumption.

Memory Bandwidth

As far as performance goes, the GeForce GTX 650 Ti 2GB should theoretically be quite a bit superior to the Radeon HD 4850 512MB overall. (explain)

GeForce GTX 650 Ti 2GB		86400 MB/sec
Radeon HD 4850 512MB		63552 MB/sec
	Difference: 22848 (36%)

Texel Rate

The GeForce GTX 650 Ti 2GB will be a lot (approximately 138%) better at AF than the Radeon HD 4850 512MB. (explain)

GeForce GTX 650 Ti 2GB		59392 Mtexels/sec
Radeon HD 4850 512MB		25000 Mtexels/sec
	Difference: 34392 (138%)

Pixel Rate

If using a high resolution is important to you, then the GeForce GTX 650 Ti 2GB is a better choice, and very much so. (explain)

GeForce GTX 650 Ti 2GB		14848 Mpixels/sec
Radeon HD 4850 512MB		10000 Mpixels/sec
	Difference: 4848 (48%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the max amount of information (in units of megabytes per second) that can be transferred across the external memory interface in a second. It is worked out by multiplying the card's bus width by the speed of its memory. In the case of DDR RAM, it should be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and higher screen resolutions.

Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are processed in one second. This figure is worked out by multiplying the total amount of texture units by the core speed of the chip. The better the texel rate, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second.

Pixel Rate: Pixel rate is the most pixels that the graphics card can possibly write to the local memory in one second - measured in millions of pixels per second. The number is calculated by multiplying the amount of ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel rate also depends on lots of other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the potential to get to the max fill rate.