Radeon HD 4770 vs Radeon HD 6670 (OEM) 1GB

Intro

Compare all that to the Radeon HD 6670 (OEM) 1GB, which has a core clock speed of 800 MHz and a GDDR5 memory frequency of 1000 MHz. It also uses a 128-bit memory bus, and makes use of a 40 nm design. It is made up of 480 SPUs, 24 Texture Address Units, and 8 ROPs.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

Radeon HD 6670 (OEM) 1GB		63 Watts
Radeon HD 4770		80 Watts
	Difference: 17 Watts (27%)

Memory Bandwidth

The Radeon HD 6670 (OEM) 1GB should theoretically be a lot faster than the Radeon HD 4770 in general. (explain)

Radeon HD 6670 (OEM) 1GB		64000 MB/sec
Radeon HD 4770		51200 MB/sec
	Difference: 12800 (25%)

Texel Rate

The Radeon HD 4770 is quite a bit (approximately 25%) better at texture filtering than the Radeon HD 6670 (OEM) 1GB. (explain)

Radeon HD 4770		24000 Mtexels/sec
Radeon HD 6670 (OEM) 1GB		19200 Mtexels/sec
	Difference: 4800 (25%)

Pixel Rate

If running with a high resolution is important to you, then the Radeon HD 4770 is superior to the Radeon HD 6670 (OEM) 1GB, by far. (explain)

Radeon HD 4770		12000 Mpixels/sec
Radeon HD 6670 (OEM) 1GB		6400 Mpixels/sec
	Difference: 5600 (88%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the largest amount of data (measured in MB per second) that can be transported past the external memory interface in a second. It's worked out by multiplying the card's interface width by the speed of its memory. In the case of DDR type memory, it must be multiplied by 2 once again. If DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the faster the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions.

Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be applied in one second. This figure is worked out by multiplying the total amount of texture units by the core clock speed of the chip. The better this number, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second.

Pixel Rate: Pixel rate is the most pixels that the graphics chip could possibly write to the local memory per second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of colour ROPs by the the core speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel rate also depends on lots of other factors, especially the memory bandwidth - the lower the bandwidth is, the lower the ability to reach the max fill rate.