Compare any two graphics cards:
Radeon HD 6750 1GB vs Radeon RX 470 4GB
IntroThe Radeon HD 6750 1GB comes with clock speeds of 725 MHz on the GPU, and 1000 MHz on the 1024 MB of GDDR5 RAM. It features 720 SPUs as well as 36 Texture Address Units and 16 Rasterization Operator Units.Compare those specs to the Radeon RX 470 4GB, which features GPU core speed of 926 MHz, and 4096 MB of GDDR5 RAM set to run at 1650 MHz through a 256-bit bus. It also is made up of 2048 Stream Processors, 128 Texture Address Units, and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the Radeon RX 470 4GB should be much faster than the Radeon HD 6750 1GB in general. (explain)
Texel RateThe Radeon RX 470 4GB should be a lot (about 354%) faster with regards to AF than the Radeon HD 6750 1GB. (explain)
Pixel RateIf using lots of anti-aliasing is important to you, then the Radeon RX 470 4GB is a better choice, by a large margin. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of data (measured in megabytes per second) that can be moved past the external memory interface in one second. The number is calculated by multiplying the interface width by the speed of its memory. If it uses DDR RAM, it must be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The better the bandwidth is, the faster the card will be in general. It especially helps with AA, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be applied per second. This is calculated by multiplying the total amount of texture units of the card by the core clock speed of the chip. The better the texel rate, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in one second. Pixel Rate: Pixel rate is the maximum number of pixels the video card can possibly write to the local memory per second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of colour ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel rate is also dependant on lots of other factors, especially the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!