Radeon HD 6770 1GB vs Radeon R7 250X 2GB

Intro

Compare all that to the Radeon R7 250X 2GB, which makes use of a 28 nm design. AMD has set the core frequency at 1000 MHz. The GDDR5 RAM runs at a frequency of 1125 MHz on this specific model. It features 640 SPUs along with 40 Texture Address Units and 16 ROPs.

Display Graphs

Hide Graphs

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

Radeon R7 250X 2GB		95 Watts
Radeon HD 6770 1GB		108 Watts
	Difference: 13 Watts (14%)

Memory Bandwidth

Theoretically speaking, the Radeon R7 250X 2GB should perform just a bit faster than the Radeon HD 6770 1GB overall. (explain)

Radeon R7 250X 2GB		72000 MB/sec
Radeon HD 6770 1GB		67200 MB/sec
	Difference: 4800 (7%)

Texel Rate

The Radeon R7 250X 2GB will be a bit (approximately 11%) faster with regards to texture filtering than the Radeon HD 6770 1GB. (explain)

Radeon R7 250X 2GB		40000 Mtexels/sec
Radeon HD 6770 1GB		36000 Mtexels/sec
	Difference: 4000 (11%)

Pixel Rate

If using a high screen resolution is important to you, then the Radeon R7 250X 2GB is superior to the Radeon HD 6770 1GB, but only just. (explain)

Radeon R7 250X 2GB		16000 Mpixels/sec
Radeon HD 6770 1GB		14400 Mpixels/sec
	Difference: 1600 (11%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the largest amount of data (counted in megabytes per second) that can be moved over the external memory interface in one second. The number is calculated by multiplying the bus width by its memory speed. If it uses DDR type RAM, it should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The higher the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, HDR and higher screen resolutions.

Texel Rate: Texel rate is the maximum texture map elements (texels) that can be applied per second. This number is worked out by multiplying the total number of texture units by the core clock speed of the chip. The better this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second.

Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics card could possibly write to the local memory in a second - measured in millions of pixels per second. The number is worked out by multiplying the number of colour ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - also called Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel output rate also depends on lots of other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the potential to get to the maximum fill rate.