Compare any two graphics cards:
GeForce 8800 GS vs GeForce GTX 460 1GB
IntroThe GeForce 8800 GS comes with a GPU clock speed of 550 MHz, and the 384 MB of GDDR3 RAM runs at 800 MHz through a 192-bit bus. It also is made up of 96 Stream Processors, 48 TAUs, and 12 ROPs.Compare all of that to the GeForce GTX 460 1GB, which comes with core speeds of 675 MHz on the GPU, and 900 MHz on the 1024 MB of GDDR5 memory. It features 336 SPUs as well as 56 Texture Address Units and 32 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 460 1GB should perform a lot faster than the GeForce 8800 GS in general. (explain)
Texel RateThe GeForce GTX 460 1GB should be a lot (about 43%) faster with regards to texture filtering than the GeForce 8800 GS. (explain)
Pixel RateIf running with high levels of AA is important to you, then the GeForce GTX 460 1GB is a better choice, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of information (in units of MB per second) that can be moved across the external memory interface in one second. It's calculated by multiplying the bus width by its memory clock speed. In the case of DDR type RAM, the result should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The better the memory bandwidth, the faster the card will be in general. It especially helps with AA, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be processed in one second. This figure is worked out by multiplying the total number of texture units by the core speed of the chip. The better the texel rate, the better the video card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in a second. Pixel Rate: Pixel rate is the maximum amount of pixels the graphics card could possibly write to its local memory per second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the amount of colour ROPs by the the core clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel rate is also dependant on lots of other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the ability to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!