Compare any two graphics cards:
GeForce GT 420 vs Radeon HD 6750 1GB
IntroThe GeForce GT 420 comes with a clock speed of 700 MHz and a GDDR3 memory frequency of 900 MHz. It also uses a 128-bit memory bus, and uses a 40 nm design. It is comprised of 48 SPUs, 8 TAUs, and 4 Raster Operation Units.Compare that to the Radeon HD 6750 1GB, which comes with clock speeds of 725 MHz on the GPU, and 1000 MHz on the 1024 MB of GDDR5 RAM. It features 720 SPUs as well as 36 Texture Address Units and 16 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthIn theory, the Radeon HD 6750 1GB should be much faster than the GeForce GT 420 in general. (explain)
Texel RateThe Radeon HD 6750 1GB is much (about 366%) faster with regards to anisotropic filtering than the GeForce GT 420. (explain)
Pixel RateIf using a high screen resolution is important to you, then the Radeon HD 6750 1GB is a better choice, by a large margin. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the maximum amount of data (measured in MB per second) that can be transported past the external memory interface within a second. It's calculated by multiplying the interface width by its memory speed. In the case of DDR type RAM, it must be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The higher the bandwidth is, the better the card will be in general. It especially helps with anti-aliasing, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are processed per second. This is calculated by multiplying the total texture units of the card by the core clock speed of the chip. The higher the texel rate, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels per second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics card can possibly write to the local memory in a second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the amount of Render Output Units by the the card's clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel rate also depends on lots of other factors, most notably the memory bandwidth - the lower the memory bandwidth is, the lower the potential to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!