Compare any two graphics cards:
GeForce GT 340 1GB vs Radeon HD 5450
IntroThe GeForce GT 340 1GB comes with core clock speeds of 550 MHz on the GPU, and 850 MHz on the 1024 MB of GDDR5 RAM. It features 96 SPUs as well as 32 Texture Address Units and 8 ROPs.Compare that to the Radeon HD 5450, which features a clock frequency of 650 MHz and a DDR3 memory speed of 800 MHz. It also makes use of a 64-bit bus, and uses a 40 nm design. It is comprised of 80(16x5) SPUs, 8 TAUs, and 4 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe GeForce GT 340 1GB should in theory perform a lot faster than the Radeon HD 5450 overall. (explain)
Texel RateThe GeForce GT 340 1GB should be a lot (approximately 238%) more effective at anisotropic filtering than the Radeon HD 5450. (explain)
Pixel RateIf using a high resolution is important to you, then the GeForce GT 340 1GB is superior to the Radeon HD 5450, by far. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of data (in units of megabytes per second) that can be transported across the external memory interface in a second. It's worked out by multiplying the interface width by its memory clock speed. If it uses DDR type RAM, the result should be multiplied by 2 again. If DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be applied per second. This figure is calculated by multiplying the total amount of texture units of the card by the core clock speed of the chip. The better this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels in one second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics card could possibly write to the local memory per second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel output rate is also dependant on many other factors, most notably the memory bandwidth of the card - the lower the memory bandwidth is, the lower the potential to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!