Compare any two graphics cards:
GeForce GTX 650 Ti 2GB vs Radeon R9 M390X
IntroThe GeForce GTX 650 Ti 2GB uses a 28 nm design. nVidia has set the core speed at 928 MHz. The GDDR5 RAM is set to run at a frequency of 1350 MHz on this card. It features 768 SPUs along with 64 TAUs and 16 ROPs.Compare those specs to the Radeon R9 M390X, which comes with a GPU core clock speed of 723 MHz, and 4096 MB of GDDR5 memory running at 1250 MHz through a 256-bit bus. It also is comprised of 2048 Stream Processors, 128 Texture Address Units, and 32 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon R9 M390X should theoretically perform much faster than the GeForce GTX 650 Ti 2GB in general. (explain)
Texel RateThe Radeon R9 M390X will be much (approximately 56%) more effective at anisotropic filtering than the GeForce GTX 650 Ti 2GB. (explain)
Pixel RateThe Radeon R9 M390X is much (about 56%) more effective at full screen anti-aliasing than the GeForce GTX 650 Ti 2GB, and capable of handling higher screen resolutions without losing too much performance. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the maximum amount of data (in units of MB per second) that can be transported over the external memory interface in a second. It's calculated by multiplying the card's bus width by its memory speed. If it uses DDR memory, the result should be multiplied by 2 once again. If DDR5, multiply by ANOTHER 2x. The higher the card's memory bandwidth, the faster the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be processed in one second. This figure is worked out by multiplying the total number of texture units by the core clock speed of the chip. The higher the texel rate, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in one second. Pixel Rate: Pixel rate is the most pixels the graphics card can possibly record to the local memory per second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of Raster Operations Pipelines by the the core clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel fill rate is also dependant on quite a few other factors, most notably the memory bandwidth - the lower the bandwidth is, the lower the ability to get to the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!