GeForce GTX 860M vs Radeon HD 7770

Intro

Compare those specifications to the Radeon HD 7770, which comes with a GPU core clock speed of 1000 MHz, and 1024 MB of GDDR5 memory set to run at 1125 MHz through a 128-bit bus. It also features 640 SPUs, 40 Texture Address Units, and 16 Raster Operation Units.

Display Graphs

Hide Graphs

Benchmarks

These are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.

3DMark Fire Strike Graphics Score

GeForce GTX 860M		4340 points
Radeon HD 7770		3180 points
	Difference: 1160 (36%)

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce GTX 860M		45 Watts
Radeon HD 7770		80 Watts
	Difference: 35 Watts (78%)

Memory Bandwidth

Theoretically speaking, the Radeon HD 7770 is 13% quicker than the GeForce GTX 860M in general, due to its higher bandwidth. (explain)

Radeon HD 7770		72000 MB/sec
GeForce GTX 860M		64000 MB/sec
	Difference: 8000 (13%)

Texel Rate

The GeForce GTX 860M should be a lot (approximately 91%) faster with regards to texture filtering than the Radeon HD 7770. (explain)

GeForce GTX 860M		76512 Mtexels/sec
Radeon HD 7770		40000 Mtexels/sec
	Difference: 36512 (91%)

Pixel Rate

If running with a high screen resolution is important to you, then the Radeon HD 7770 is a better choice, and very much so. (explain)

Radeon HD 7770		16000 Mpixels/sec
GeForce GTX 860M		12752 Mpixels/sec
	Difference: 3248 (25%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Memory bandwidth is the maximum amount of data (in units of megabytes per second) that can be transported across the external memory interface within a second. The number is calculated by multiplying the interface width by its memory speed. If it uses DDR RAM, it must be multiplied by 2 again. If it uses DDR5, multiply by ANOTHER 2x. The better the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and high resolutions.

Texel Rate: Texel rate is the maximum number of texture map elements (texels) that can be applied per second. This figure is calculated by multiplying the total texture units by the core speed of the chip. The better this number, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second.

Pixel Rate: Pixel rate is the most pixels the graphics card could possibly write to its local memory in a second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the number of Render Output Units by the the core clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate also depends on lots of other factors, especially the memory bandwidth - the lower the bandwidth is, the lower the ability to reach the max fill rate.