Compare any two graphics cards:
Radeon HD 4830 512MB vs Radeon R9 M275X
IntroThe Radeon HD 4830 512MB features a GPU core speed of 575 MHz, and the 512 MB of GDDR3 RAM is set to run at 900 MHz through a 256-bit bus. It also is made up of 640(128x5) SPUs, 32 TAUs, and 16 Raster Operation Units.Compare all that to the Radeon R9 M275X, which features a clock speed of 900 MHz and a GDDR5 memory speed of 1125 MHz. It also features a 128-bit memory bus, and uses a 28 nm design. It features 640 SPUs, 40 Texture Address Units, and 16 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon R9 M275X should theoretically perform much faster than the Radeon HD 4830 512MB in general. (explain)
Texel RateThe Radeon R9 M275X will be much (more or less 96%) more effective at AF than the Radeon HD 4830 512MB. (explain)
Pixel RateIf using a high resolution is important to you, then the Radeon R9 M275X is a better choice, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of data (in units of megabytes per second) that can be transported over the external memory interface in one second. It's worked out by multiplying the card's interface width by its memory clock speed. If it uses DDR type RAM, it must be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The better the card's memory bandwidth, the better the card will be in general. It especially helps with AA, HDR and higher screen resolutions. Texel Rate: Texel rate is the maximum number of texture map elements (texels) that are processed in one second. This number is calculated by multiplying the total texture units of the card by the core clock speed of the chip. The higher this number, the better the graphics card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in one second. Pixel Rate: Pixel rate is the most pixels that the graphics card can possibly record to the local memory per second - measured in millions of pixels per second. The figure is calculated by multiplying the number of Render Output Units by the clock speed of the card. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate also depends on quite a few other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the ability to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!