Compare any two graphics cards:
GeForce 9800 GT 512MB vs GeForce GTX 750 Ti
IntroThe GeForce 9800 GT 512MB features a GPU clock speed of 600 MHz, and the 512 MB of GDDR3 RAM is set to run at 900 MHz through a 256-bit bus. It also features 112 Stream Processors, 56 TAUs, and 16 ROPs.Compare all of that to the GeForce GTX 750 Ti, which comes with GPU core speed of 1020 MHz, and 2048 MB of GDDR5 memory running at 1350 MHz through a 128-bit bus. It also features 640 SPUs, 40 Texture Address Units, and 16 Raster Operation Units.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthIn theory, the GeForce GTX 750 Ti will be 50% faster than the GeForce 9800 GT 512MB in general, due to its higher bandwidth. (explain)
Texel RateThe GeForce GTX 750 Ti is much (approximately 21%) faster with regards to anisotropic filtering than the GeForce 9800 GT 512MB. (explain)
Pixel RateThe GeForce GTX 750 Ti will be much (about 70%) more effective at full screen anti-aliasing than the GeForce 9800 GT 512MB, and will be capable of handling higher screen resolutions without losing too much performance. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of data (in units of megabytes per second) that can be transferred past the external memory interface within a second. The number is calculated by multiplying the bus width by its memory clock speed. In the case of DDR RAM, it must be multiplied by 2 once again. If DDR5, multiply by ANOTHER 2x. The higher the memory bandwidth, the better the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be processed per second. This number is worked out by multiplying the total texture units of the card by the core clock speed of the chip. The higher the texel rate, the better the card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in a second. Pixel Rate: Pixel rate is the most pixels the graphics card can possibly write to the local memory in one second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of Raster Operations Pipelines by the the core clock speed. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate is also dependant on quite a few other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the potential to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!