GeForce GTX 560 Ti vs GeForce GTX 750 Ti

Intro

Compare all of that to the GeForce GTX 750 Ti, which uses a 28 nm design. nVidia has clocked the core speed at 1020 MHz. The GDDR5 memory is set to run at a frequency of 1350 MHz on this specific card. It features 640 SPUs as well as 40 Texture Address Units and 16 ROPs.

Display Graphs

Hide Graphs

Benchmarks

These are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.

3DMark Fire Strike Graphics Score

GeForce GTX 750 Ti		4562 points
GeForce GTX 560 Ti		3466 points
	Difference: 1096 (32%)

Power Usage and Theoretical Benchmarks

Power Consumption (Max TDP)

GeForce GTX 750 Ti		60 Watts
GeForce GTX 560 Ti		170 Watts
	Difference: 110 Watts (183%)

Memory Bandwidth

Theoretically speaking, the GeForce GTX 560 Ti should perform much faster than the GeForce GTX 750 Ti overall. (explain)

GeForce GTX 560 Ti		128256 MB/sec
GeForce GTX 750 Ti		86400 MB/sec
	Difference: 41856 (48%)

Texel Rate

The GeForce GTX 560 Ti will be quite a bit (about 29%) faster with regards to texture filtering than the GeForce GTX 750 Ti. (explain)

GeForce GTX 560 Ti		52608 Mtexels/sec
GeForce GTX 750 Ti		40800 Mtexels/sec
	Difference: 11808 (29%)

Pixel Rate

The GeForce GTX 560 Ti will be much (more or less 61%) more effective at anti-aliasing than the GeForce GTX 750 Ti, and also will be able to handle higher screen resolutions without slowing down too much. (explain)

GeForce GTX 560 Ti		26304 Mpixels/sec
GeForce GTX 750 Ti		16320 Mpixels/sec
	Difference: 9984 (61%)

Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit.

Price Comparison

Specifications

Memory Bandwidth: Bandwidth is the max amount of information (counted in megabytes per second) that can be transferred past the external memory interface in one second. It is worked out by multiplying the card's interface width by its memory clock speed. If the card has DDR memory, the result should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The higher the bandwidth is, the better the card will be in general. It especially helps with AA, High Dynamic Range and high resolutions.

Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that are applied in one second. This figure is worked out by multiplying the total amount of texture units of the card by the core clock speed of the chip. The higher this number, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed per second.

Pixel Rate: Pixel rate is the most pixels that the graphics card could possibly write to its local memory in a second - measured in millions of pixels per second. The figure is calculated by multiplying the amount of colour ROPs by the clock speed of the card. ROPs (Raster Operations Pipelines - also sometimes called Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel output rate is also dependant on lots of other factors, most notably the memory bandwidth of the card - the lower the bandwidth is, the lower the ability to reach the maximum fill rate.