Compare any two graphics cards:
GeForce GTX 750 Ti vs Radeon R9 290X
IntroThe GeForce GTX 750 Ti makes use of a 28 nm design. nVidia has clocked the core frequency at 1020 MHz. The GDDR5 RAM runs at a speed of 1350 MHz on this particular model. It features 640 SPUs along with 40 Texture Address Units and 16 ROPs.Compare those specs to the Radeon R9 290X, which comes with a GPU core clock speed of 800 MHz, and 4096 MB of GDDR5 memory set to run at 1250 MHz through a 512-bit bus. It also is made up of 2816 Stream Processors, 176 TAUs, and 64 ROPs.
Display Graphs
BenchmarksThese are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.
3DMark Fire Strike Graphics Score
Zcash Mining Hash Rate
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthThe Radeon R9 290X should theoretically perform much faster than the GeForce GTX 750 Ti in general. (explain)
Texel RateThe Radeon R9 290X is quite a bit (approximately 245%) more effective at AF than the GeForce GTX 750 Ti. (explain)
Pixel RateIf using high levels of AA is important to you, then the Radeon R9 290X is a better choice, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the max amount of information (counted in MB per second) that can be transported over the external memory interface in one second. It's worked out by multiplying the card's interface width by the speed of its memory. In the case of DDR type memory, the result should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The better the card's memory bandwidth, the faster the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be applied per second. This figure is calculated by multiplying the total texture units by the core clock speed of the chip. The better this number, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in a second. Pixel Rate: Pixel rate is the maximum number of pixels that the graphics chip could possibly record to the local memory per second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the number of colour ROPs by the the card's clock speed. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for outputting the pixels (image) to the screen. The actual pixel fill rate also depends on lots of other factors, especially the memory bandwidth of the card - the lower the bandwidth is, the lower the potential to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!