Compare any two graphics cards:
Radeon HD 5750 512MB vs Radeon HD 6670 (OEM) 1GB
IntroThe Radeon HD 5750 512MB features a clock frequency of 700 MHz and a GDDR5 memory frequency of 1150 MHz. It also features a 128-bit bus, and makes use of a 40 nm design. It is comprised of 720(144x5) SPUs, 36 Texture Address Units, and 16 ROPs.Compare those specs to the Radeon HD 6670 (OEM) 1GB, which features core speeds of 800 MHz on the GPU, and 1000 MHz on the 1024 MB of GDDR5 RAM. It features 480 SPUs along with 24 TAUs and 8 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthAs far as performance goes, the Radeon HD 5750 512MB should theoretically be just a bit better than the Radeon HD 6670 (OEM) 1GB overall. (explain)
Texel RateThe Radeon HD 5750 512MB is much (approximately 31%) better at AF than the Radeon HD 6670 (OEM) 1GB. (explain)
Pixel RateIf using a high resolution is important to you, then the Radeon HD 5750 512MB is a better choice, and very much so. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of data (counted in megabytes per second) that can be transported across the external memory interface in a second. The number is worked out by multiplying the card's interface width by its memory speed. If it uses DDR memory, it should be multiplied by 2 once again. If it uses DDR5, multiply by 4 instead. The higher the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and high resolutions. Texel Rate: Texel rate is the maximum texture map elements (texels) that can be applied in one second. This is calculated by multiplying the total texture units by the core clock speed of the chip. The better this number, the better the video card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied in a second. Pixel Rate: Pixel rate is the maximum number of pixels that the graphics card could possibly record to its local memory per second - measured in millions of pixels per second. The number is calculated by multiplying the amount of Render Output Units by the clock speed of the card. ROPs (Raster Operations Pipelines - sometimes also referred to as Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel rate is also dependant on lots of other factors, especially the memory bandwidth - the lower the memory bandwidth is, the lower the ability to reach the max fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!